Found a Possibe Source for Christopher Schwarz' favorite Striking Knife!

A while back, Christopher Schwarz showed us his favorite striking knife. I decided I needed to make one. Before I do however, I probably need to try out one of the ones shown on this page.

This one may be hard to sharpen, considering that it is solid carbide.

Bob

March 17th, 2009 | Category: Hand Tools, Tools | 4 comments

Tom Fidgen's Blog

Tom Fidgen emailed me and offered a link exchange. I looked for his site and did a bit of looking around on the net and found his talents were not just limited to woodwork.

His music, the music he composes and plays, is quite superb. His taste in tools exquisite, and his craftsmanship [...]

March 13th, 2009 | Category: Hand Tools, Tools, Woodworking | 4 comments

An Elegant Bevel Gauge

Over at Dan’s Shop is an article describing a bevel gauge. This is a simple enough tool that has fixed angles for 90, 60. 45 and 30 degrees. The lines are simple and the layout is simple. Better yet, these are the angles that I tend to use most. I [...]

March 12th, 2009 | Category: Hand Tools, Tools, Woodworking | 2 comments

Ferrules

When making simple hand tools, a ferrule is an important addition.

The ferrule on the knife was made by heating a nut on punch, to a nice cherry red an then beating it with a hammer. This gave it a good angled inner surface that jams on tight to a wooden mortise. This makes [...]

March 11th, 2009 | Category: Hand Tools, Metalworking, Tool Making, Tools | 10 comments

Jointmaker Pro Showing Up Now!

A few folk on blogs  have mentioned getting their Jointmaker Pro.   Mine will probably ship today or tomorrow!   I am hoping, today!

At the Festool Owners Group, two of the participants have mentioned getting their JMP and that it was a lot of parts to put together, but it has gone together wonderfully as it was [...]

March 10th, 2009 | Category: Hand Tools, Tools | 8 comments
« Newer Entries  
  Older Entries »