Here is my first attempt at making a folding knife.
Bob
|
Simple project, a nice little dovetail saw. The long handle helps me to make straight cuts. Pretty simple project here, two holes for screws, a slit for the saw. Does a nice job too! The blade I used is sold by Lee Valley Tools. Item number 60T0621 It is a Japanese Kugihiki. A […] Here is a photo of the Froe Mallet I made. Even though I had not used one on a froe, the motive for the design is obvious. A rough surface will absorb some of the womp, so you want a smooth hard wood surface. But you are going to be pounding on a […] Luke Townsley has done the brilliant work of creating an aggregation of recent articles. I had not even thought of this concept, apart from my RSS feed collection, but he kindly emailed me and let me know that Toolmaking Art has been added. What a delightful surprise. I looked over his site, http://www.unpluggedshop.com/ and found […] Less bad than the loose grit on the table, but still a poor one. I figured the spit in the table would be perfect for sawing. I had to move it a bit further out, The cut was however way off. The angle did not help my acuracy one bit. After sawing flat, […] |
||
|
Copyright © 2025 Toolmaking Art - All Rights Reserved Powered by WordPress & Atahualpa |
||
A page Dedicated to My Writing
Recent Comments